So, hab's jetzt nochmal probiert und mich im Wesentlichen auf http://www.dhaller.de/linux/multikernel.html und die Tipps aus dieser Mailingliste gestützt. Diesemal läuft das System aber ohne SCSI Controller! Ich bin also wie folgt vorgegangen (Sorry, was folgt ist eine Art Protokoll für die spätere Doku und in Englisch, ich hoffe es ist auch verständlich): copied the linux-2.4.19.tar.gz to /usr/src extracted linux-2.4.19.tar.gz in /usr/src mv /usr/src/linux-2.4.19 to /usr/src/linux-2.4.19a created link in /usr/src/linux to /usr/src/linux-2.4.19a discommented line "export INSTALL_PATH=/boot" in Makefile let run make oldconfig in case of no .config is available zcat /proc/config.gz .config make oldconfig gzip -cd < linux-2.4.19.xattr+acl-0.8.50.diff.gz | patch -p1 make menuconfig vi Makefile (EXTRAVERSION=a) time make dep clean bzImage modules modules_install 2>&1 | tee make.out cp /usr/src/linux/arch/i386/boot/bzImage /boot/vmlinuz-2.4.19a cp /usr/src/linux/System.map /boot/System.map-2.4.19a mv /boot/vmlinuz /boot/vmlinz-2.4.10-4GB (altes Image gesichert) vi /etc/lilo.conf angepasst lilo lilo.conf: boot = /dev/hda vga = 785 read-only menu-scheme = Wg:kw:Wg:Wg lba32 prompt timeout = 80 message = /boot/message image = /boot/vmlinuz-2.4.10-4GB label = 2.4.10-4GB root = /dev/hda3 initrd = /boot/initrd append = "enableapic vga=0x0311" image = /boot/vmlinuz-2.4.19a label = 2.4.19a-acl root = /dev/hda3 initrd = /boot/initrd append = "enableapic vga=0x0311" image = /boot/vmlinuz.suse label = failsafe root = /dev/hda3 initrd = /boot/initrd.suse append = "disableapic ide=nodma apm=off" optional image = /boot/memtest.bin label = memtest86 Trotz dieses -meiner Meinung nach richtigen- Vorgehens, kann ich den neuen Kernel nicht starten. Was ist denn jetzt noch falsch?? Danke für die Hilfe Peter Meyer -- GMX - Die Kommunikationsplattform im Internet. http://www.gmx.net