Hallo Leute, hatte gerade so gut geklappt, jetzt habe ich das Problem wieder. dmesg sagt "visor 1-2:1.0: device disconnected usb 1-2: new full speed USB device using uhci_hcd and address 12 visor 1-2:1.0: Handspring Visor / Palm OS converter detected usb 1-2: Handspring Visor / Palm OS converter now attached to ttyUSB0 usb 1-2: Handspring Visor / Palm OS converter now attached to ttyUSB1 usb 1-2: USB disconnect, address 12 visor ttyUSB0: Handspring Visor / Palm OS converter now disconnected from ttyUSB0 visor ttyUSB1: Handspring Visor / Palm OS converter now disconnected from ttyUSB1" Also Link von USB1 nach dev/pilot. Geht erst. Dann Geräte ab. Unterwegs. Dann Gerät wieder dran "usb 1-2: new full speed USB device using uhci_hcd and address 13 visor 1-2:1.0: Handspring Visor / Palm OS converter detected usb 1-2: Handspring Visor / Palm OS converter now attached to ttyUSB0 usb 1-2: Handspring Visor / Palm OS converter now attached to ttyUSB1" Hotsyncknopf gedrückt: "HotSync-Protokoll 09:14:41 Der Status des Dämons ist "Waiting for sync" 09:14:49 Der nächste Abgleich wird HotSync sein. Bitte HotSync-Knopf drücken. 09:14:49 Pilot-Gerät /dev/pilot existiert nicht. Das Gerät ist wahrscheinlich ein USB Gerät und erscheint erst während einem Abgleich." Scheisse! Alles meldet sich ordnungsgemäß. Umgehung für Zire72 habe ich eingeschaltet. Was damit auch immer umgangen werden soll. Ich habe keine Ahnung wovon das abhängig ist. Mit meinem alten Palm Zire71 geht das über ttyS0 hervorragend. USB ist scheinbar immer noch ein Problem. Wer kann mir mal helfen das auf Dauer hinzubekommen. mfg. Andreas