Am Montag August 2 2004 02:40 schrieb David Haller: [...]
==== HDPARM(8) HDPARM(8) [..] -k Get/set the keep_settings_over_reset flag for the drive. When this flag is set, the driver will pre serve the -dmu options over a soft reset, (as done during the error recovery sequence). This flag defaults to off, to prevent drive reset loops which could be caused by combinations of -dmu settings. The -k flag should therefore only be set after one has achieved confidence in correct system operation with a chosen set of configuration settings. ====
(dabei bezeichnet '-dmu' '-d' und/oder '-m' und/oder '-u').
Wenn's also funktioniert dann sollte man '-k 1' in den hdparm-Aufruf einbauen, denn der IDE-Bus wird durchaus auch bei normalem Betrieb haeufiger resettet...
Ich kenne das Flag, nur in manchen Fällen hilft das nicht, vorallem bei älteren Systemen. Ich habe auch schon erlebt, dass -k1 nicht akzeptiert wurde. Gruß Udo -- Vulcans worship peace above all. -- McCoy, "Return to Tomorrow", stardate 4768.3