Moin Moin!
EAZ/MSN: Phone number(s): Outgoing: <-----------Keine MSN vergeben Incoming: (...)
Ich hab' bei Hardware eine MSN angegeben und das dann gespeichert. Aber warum das da nicht steht, weiß ich nicht!
Bist Du sicher, dass Du ippp0 mit YaST vollstaending angelegt und aktiviert hast?
Liefert ifconfig ippp0 error fetching interface information: Device not found ? Inzwischen gibt es ein ippp0! Frag nicht warum. Vielleicht hat er nur etwas Zeit und ein paar mal booten gebraucht :-) Also: ippp0 Link encap:Ethernet HWaddr FC:FC:C0:A8:00:63 inet addr:192.168.0.99 P-t-P:192.168.0.1 Mask:255.255.255.255 UP POINTOPOINT RUNNING NOARP DYNAMIC MTU:1500 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:30
Wie sehen die Zeilen in /etc/rc.config aus?
NETDEV_0="eth0" NETDEV_1="eth1" NETDEV_2="ippp0" IFCONFIG_0="192.168.0.1 broadcast 192.168.0.255 netmask 255.255.255.0 up" IFCONFIG_1="192.168.22.99 broadcast 192.168.22.255 netmask 255.255.255.0 up" IFCONFIG_2="192.168.0.99 dynamic pointopoint 192.168.0.1 up" IFCONFIG_3=""
Geh nochmal in den YaST, konfiguriere auch Hardware und ISDN und stelle sicher, dass das device aktiviert ist.
BTW: vbox hat nüscht mit ippp0 zu tun, eher ttyI6, also, ganz andere Baustelle. Ich weiß, damit habe ich früher schon mal gekämpft :)
Ich hoffe, das sieht erst einmal alles gut aus. Aber mein Problem mit kimon ist immer noch da! Die Fehlemeldung sieht so aus: Thilo@desktop:~ > kimon ippp0: Das Argument ist ungültig Was soll ich denn jetzt machen? Gruß und vielen Dank für die Mühe Thilo