Hello, I had somewhere in my mind than the printer module of YaST had been rewritten. I hope it's not the case or the Leap one is not this, because it's a big mess. I have two printer, one HP, the other Brother. I first tried YaST. Installed the HP (usb) printer without problem. I couldn't install the Brother (network) printer because the necessary ppd file was not present. Not a big deal, I downloaded the Brother installer. The result was the Brother printer installed as hp printer... with the same connection as the HP printer, so that any print targeting the Brother printer was printed (sort of) by the HP one!! This may not be YaST fault. But in Yast I couldn't fix the problem. Impossible to remove a wrong line in the "edit" part of the yast module, I could only add lines. When asked to enter an URI, I tried 192.168.0.17 (the printer IP), refused (->incorrect URI), 192.168.0.17:9100 refused. I tried to remove the two printers in the first YaST windows, but this didn't remove the faulty lines in the "edit" windows. Thanksfully I could add my two printers in a snap with cups original interface. May be the only problem is the lack of examples (the cups pages gives thee examples - the best for the Brother printer is "socket://192.168.0.17:9100" and this is for years). The ppd was added by the Brother installer. But there should definitely be some way (obvious way) to remove bad lines in the editor. In fact I think this module is bad for so many years it should be removed and simply do a link to localhost:631. sorry... jdd -- To unsubscribe, e-mail: opensuse-factory+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse-factory+owner@opensuse.org