В Fri, 01 Mar 2013 21:18:28 +0100
Freek de Kruijf
Op vrijdag 1 maart 2013 18:04:28 schreef u:
Op vrijdag 1 maart 2013 11:27:54 schreef Roman Bysh:
Hello all,
I've installed openSUSE 12.3 RC2 on my desktop.Does any one know if the plasmoid-networkmanagement will be working in time for the final release?
Now that I've already set it up under YaST.
I have an ethernet cable connected to my desktop. However, under the "Wired" tab nothing appears. It should show "Wired connection 1".
I installed it using the DVD image of RC2 in a VM, which is comparable with your type of installation in my experience, and got the network mode Traditional Method with ifup. In that case you can start the plasmoid, but you don't get anything under "Wired". So check with "systemctl -p Id show network.service" the status, see the release notes for further information. If you get Id=NetworkManager.service maybe a reboot and starting the plasmoid may give you the possibility to configure the network using NetworkManager. If not, you get Id=network.service, the procedure given in the release notes to really change to NetworkManager may work. This does not work in YaST.
In my view the network module of YaST still lacks the proper functionality to switch between the Traditional and NetworkManager method. Also the description in the Release Notes is not very clear. It should state that the network module of YaST currently is unable to change from Traditional to NetworkManager and vice versa. So if you want to do that you can the use the procedure given in the Release Notes if it works. I still have not fully tested it.
After some digging in the log file /var/log/y2log I found the error which causes the problem of not changing the network.service from pointing to NetworkManager.service or just to itself (/etc/init.d/network).
When only changing from Traditional to NetworkManager the network module of YaST sets this in the configuration and issues a "/bin/systemctl reload network.service" which does not work. The error message is "Job type reload is not applicable for unit network.service". YaST does not issue an error message to the user. So this error gets unnoticed.
For the maintainer: Line 570 in modules/Lan.ycp needs a more complicated treatment. Now it just reads: Service::Reload("network"); without any error checking.
Did you report it to bugzilla? -- To unsubscribe, e-mail: opensuse-factory+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse-factory+owner@opensuse.org