https://bugzilla.novell.com/show_bug.cgi?id=384210 Summary: Regression: b43 driver don't work Product: openSUSE 11.0 Version: Beta 1 Platform: i386 OS/Version: openSUSE 11.0 Status: NEW Severity: Major Priority: P5 - None Component: Other AssignedTo: bnc-team-screening@forge.provo.novell.com ReportedBy: zuntrak@gmail.com QAContact: qa@suse.de Found By: Other In opensuse 10.3, my wireless card is controled by the bcm43xx driver, after the installation of the firmware, the hardware works well. But opensuse 11.0-beta1 uses the b43 driver and I tried a lot of ways but the hardware don't works; i change to the b43legacy driver, installed the firmwares and still don't work my wireless card. Some usefull information: -I am using a acer aspire 5710z laptop -lspci: 04:00.0 Ethernet controller: Broadcom Corporation NetLink BCM5787M Gigabit Ethernet PCI Express (rev 02) 05:00.0 Network controller: Broadcom Corporation BCM94311MCG wlan mini-PCI (rev 01) -iwconfig: lo no wireless extensions. eth0 no wireless extensions. wlan0 IEEE 802.11g ESSID:"" Mode:Managed Frequency:2.412 GHz Access Point: Not-Associated Tx-Power=27 dBm Retry min limit:7 RTS thr:off Fragment thr=2352 B Encryption key:off Link Quality:0 Signal level:0 Noise level:0 Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 Tx excessive retries:0 Invalid misc:0 Missed beacon:0 - the 'iwlist wlan0 scan' works and i can see the accespoints but knetworkmanager shows nothing -dhclient: dhclient Internet Systems Consortium DHCP Client V3.0.6 Copyright 2004-2007 Internet Systems Consortium. All rights reserved. For info, please visit http://www.isc.org/sw/dhcp/ wmaster0_rename: unknown hardware address type 801 wmaster0_rename: unknown hardware address type 801 Listening on LPF/wlan0/00:19:7e:aa:37:89 Sending on LPF/wlan0/00:19:7e:aa:37:89 Bind socket to interface: No such device If you did not get this software from ftp.isc.org, please get the latest from ftp.isc.org and install that before requesting help. If you did get this software from ftp.isc.org and have not yet read the README, please read it before requesting help. If you intend to request help from the dhcp-server@isc.org mailing list, please read the section on the README about submitting bug reports and requests for help. Please do not under any circumstances send requests for help directly to the authors of this software - please send them to the appropriate mailing list as described in the README file. exiting. -- Configure bugmail: https://bugzilla.novell.com/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are on the CC list for the bug.