Hi all I am trying SLES10-beta8 installation to iscsi-target. When booted from SLES-10-beta8 installation Disk1, I could not goto some iscsi-GUI to give iscsi-target IP and initiatorname. Is there a iscsi-configuration-GUI/Menu available for the user during the install time? To be able to try installation to iscsi-target, I went to command-prompt(ctrl+alt+f2) and loaded drivers(iscsi_tcp, e1000), assigned static IP address, start iscsid, run iscsiadm -discovery + iscsiadm -login. I could connect to the iscsi-target and had the remote disk in the installation-partition menu. Main issue appears after the installation is started and is in the middle. The machine will freeze, can't do anything. I tried several times , and it always will freeze before being able to finish the installation. Is it the open-iscsi driver issue(version 0.5.473-11)? Or is there something I need to configure properly to be able to install to iscsi-target? I am just doing a minimal base system install. Also I noticed through local-install that there is an open-iscsi support in /sbin/mkinitrd of SLES10-beta8. Will installer automatically create iscsi enabled initrd image, once it knows installation was made to iscsi target? Thanks in advance -vikas aggarwal