Op vrijdag 24 januari 2014 09:51:04 schreef Thomas Fehr:
This would be reasonable, but unfortunately it is not true in general. My Development machine e.g. has only one network device but the kernel names it eth1, not eth0:
It looks like you are using a VM. I had the same problem when moving a virtual disk to another VM on another machine, but the same would be true if you are using a new VM on the same machine. The new VM will have a new MAC address defined on the host. This MAC address will be compared in the VM with the MAC address already in the configuration of eth0, when they differ a new device will be created, named eth1. The configuration of eth0 will still be there, but does not have an interface assigned. In case you are certain that these two VMs will not be active at the same time on the same network, you can give, on the host, the network device the same MAC address as it used earlier. In that case eth0 will be the active interface. -- fr.gr. Freek de Kruijf -- To unsubscribe, e-mail: yast-devel+unsubscribe@opensuse.org To contact the owner, e-mail: yast-devel+owner@opensuse.org