On 06/04/2016 10:49 PM, Jeffrey L. Taylor wrote:
It's a gigabit switch and you can configure it so that one port can
monitor the traffic of one or more other ports. BTW, this costs about $20 less than what I paid for an 8 port, 10 Mb hub, back in the late 90s.
Those that can afford Gb connections to the Internet can afford more expensive hardware than I can. This was a decade ago. I probably had somewhere between 2Mbps and 10Mbps connectivity.
Many people run over 100 Mb Internet connections these days, not to mentioned gigabit on the local LAN. Also, I just remembered another use for my hub. It is, in fact, a 9 port hub, with the 9th port a BNC connector on the rear panel. This means I could use that hub to connect a 10base2 coax network to a switch. Problem is, 10base2 became obsolete when 10baseT hubs appeared and are really scarce now. Incidentally, back in 1997, I was working on a project in the Ontario government buildings in "Queen's Park" in Toronto, to convert their network from 10base2 to 10baseT switched network. They went straight from 10base2 to switches, without bothering with hubs. Hubs would not have given a performance improvement over coax, but switches did. My first experience with Ethernet would have been with DECNET, connecting VAX 11/780 computers, back in the 80s. That network used the 10base5 "thick net" cables (10base2 was called "thin net"). -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse+owner@opensuse.org