18 Mar
2013
18 Mar
'13
14:43
Hi, I have installed FreeCAD 0.13 (from repository) on OpenSuSE 12.3. Installation went smooth, all dependencies were resolved. However, launch of FreeCAD 0.13 is only partial success, shell is loaded, it immediately gives error message "No module named StartGUI". Workbench -> New -> … always throws the same type of error, for example Workbench -> New -> Arch - "No module named Drawing". Anyone have any clue what might be wrong ? Thanks in advance. Andrei-- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse+owner@opensuse.org