Hi. I tried to run my ewbcam... Module is loaded but no video device presen in /dev hwinfo shows
85: USB 00.0: 0000 Unclassified device [Created at usb.122] UDI: /org/freedesktop/Hal/devices/usb_device_ac8_303b_noserial_if0 Unique ID: X7GA.ptIWmQBJbVE Parent ID: k4bc.Uu0aCsrHYoB SysFS ID: /devices/pci0000:00/0000:00:0b.0/usb1/1-7/1-7:1.0 SysFS BusID: 1-7:1.0 Hardware Class: unknown Model: "Z-Star Microelectronics ZC0303 WebCam" Hotplug: USB Vendor: usb 0x0ac8 "Z-Star Microelectronics Corp." Device: usb 0x303b "ZC0303 WebCam" Revision: "1.00" Speed: 12 Mbps Module Alias: "usb:v0AC8p303Bd0100dcFFdsc00dp00icFFiscFFipFF" Driver Info #0: Driver Status: zc0301 is not active Driver Activation Cmd: "modprobe zc0301" Config Status: cfg=new, avail=yes, need=no, active=unknown Attached to: #75 (Hub)
I added "blacklist zc0301" to /etc/modprobe.d/blacklist, because my webcam should be supported by gspca_zc3xx module. But it's not. After modprobe gspca_zc3xx, dmesg shows:
gspca: main v2.2.0 registered usbcore: registered new interface driver zc3xx zc3xx: registered
Still no video device :( With zc0301 module anables, dmesg shows:
Linux video capture interface: v2.00 zc0301: V4L2 driver for ZC0301[P] Image Processor and Control Chip v1:1.10 usb 1-7: ZC0301[P] Image Processor and Control Chip detected (vid/pid 0x0AC8:0x303B) usb 1-7: No supported image sensor detected usbcore: registered new interface driver zc0301 but still no device...
I read somewhere, that my webcam's model (0x0ac8:0x303b) is disabled in kernel...
#if !defined CONFIG_USB_ZC0301 && !defined CONFIG_USB_ZC0301_MODULE
{USB_DEVICE(0x0ac8, 0x303b)}, #endif
So how can I run my webcam? Best regards, -- Mariusz Fik openSUSE Community Member -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org For additional commands, e-mail: opensuse+help@opensuse.org