Fabian Slovig wrote:
Hello,
I've a serious problem with my Fujitsu-Siemens RX100S4 server. I want to install a SuSE Linux on it with raid. I tried SuSE 10.0 and 10.1, but I always only saw two harddisks and no raid-system in the partitioner. Then I tried openSuSE 10.2 and had a little success. It found the correct raid Controller (a ICH7; ISL MegaRAID) and the two Broadcom network-interfaces. Then in the yast it crashed down. Without raid it donÄt carsh. The message is:
device-mapper: table: 253:2: linear: dm-linear: Device lookup failed device-mapper: inctl: error adding target to table dmraid: segfault at 00002b9809130a00 rip 00002b9809130a00 rsp00007fffa22f78c8 error 15
Can you help me? I need this server running SuSE linux....
Support for Linux from FSC has been rather lacking. I've pretty much given up on FSC with Linux, even though most of our servers are from FSC. Officially they don't support any Suse aside of the SLES. Your best bet is to either use a controller that is supported natively by the kernel or try Opensuse 10.3. The RC1 that appeared last week should be sufficient to test if the installation is possible. -- Sandy List replies only please! Please address PMs to: news-reply2 (@) japantest (.) homelinux (.) com -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org For additional commands, e-mail: opensuse+help@opensuse.org