On Fri, 2007-01-12 at 07:33 +0800, Joe Morris (NTM) wrote:
Art Fore wrote:
Anyhow, I got them both working. I setup Yast to use traditional control, then set the eth0 as it was default from the installation. Then set eth1 DNS servers etc. so DHCP would not update them. Then executed the command route add gw 192.168.99.1. I could then access the wireless network via Linux with not change in WinXP.
Only remaining problems are how to get ifplugd to start the wireless at boot. Change it in Yast to startup at boot instead of on cable connection (Network Devices, Network Card, Edit your card, General Tab). eth1 was added to the ifplugd.conf file, but probably needs more time or something. Also have figure out where to put the route command so it will be executed automatically during boot.
Under Address tab, Routing
-- Joe Morris Registered Linux user 231871 running openSUSE 10.2 x86_64
That appears to have done it. Will find out for sure Monday when I go back to work. Art
-- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org For additional commands, e-mail: opensuse+help@opensuse.org