在 2006-11-14二的 20:32 +0800,张韡武写道:
在 2006-11-05日的 13:03 +0100,Peo Nilsson写道:
On Sun, 2006-11-05 at 19:23 +0800, 张韡武 wrote:
installation. Check display card properties, it shows the "Enable 3D accelerate" checkbox is in gray color, that is, I cannot check this checkbox. If nvidias driver is properly installed you should have 3D accel. Don´t bother about the checkbox in yast (enable 3D), it´s enabled nomatter what it says. Somewhere in the documentation I have read about this issue, don´t remember where though.
Thank you very much for offering this checklist to determine my problem. I believe I have nvidia driver properly installed : first by using the install source of download.nvidia.com and when it doesn't work, run the install program of nvidia to have compiled a kernel module. X starts fine.
1) What happens if you run 'glxgears' in a shell. If it runs you have 3D enabled.
I have glxgear runs fine, I can reach as much as 1800 FPS. (Before using nvidia driver I can reach only around 500 FPS with nv driver)
2) Read the mail archive, there have been a LARGE amount about the nvidia drievr.
If you still can´t get it to run properly, please feel free to post again. Also if it works out for you, do tell it in a post.
SaX2 said I have Geforce Go 6150. 3D is enabled and not possible to disable (checkbox always checked).
However gnome-xgl-setting display this information: Video card: nVidia Corporation C51 PCI Express Bridge Your video card is not in XGL's database 3D Acceleration: Disabled Desktop Effect: Disabled
I was also told that I can run SaX to fix this, but actually I can do nothing in SaX (because 3D is already enabled).
I also checked gentoo's xgl compatibility and it's clearly written my type of card is supported. Actually that's why I sold my old notebook to get this new one: in order to play with XGL effects. I checked XGL compatibility before I decide to purchase this notebook. I think if gentoo can run XGL on it, SuSE must be able to too.
Any hint?
Now I can run it! I tried this: I discovered a new command gnome-xgl-switch and I enabled XGL with this command. Reboot the computer and then xgl works! I think this should be filed as a bug: a supported brand of video card is by mistake considered not-supported and users are forbidden to activate xgl by using control center panel.
-- 锐业软服(国内业务) http://www.realss.cn Real SoftService http://www.realss.com 销售咨询(Sales Department): 0086 592 20 99987 (Chinese, German, English) 国际业务(International Sales): 0086 10 8460 6011 (German and English) 联系:厦门大学科技园,嘉庚二号楼6楼 邮政:厦门大学2312号信箱(邮编361005)