On Sunday 09 April 2006 14:11, Elijah Savage wrote:
Yeah I did use yast to set it up but after reboot the card is not detected. I go into yast and the card initializes and everything is fine.
It sounds like the module you need for the netcard isn't loaded at boot time (in initrd) Try this: hwinfo --netcard This should provide into about the new card and what module is needed. Then go to /etc/sysconfig/kernel and check what modules are included in the line: INITRD_MODULES="piix ata_piix aic7xxx processor thermal fan jbd ext3" If the needed module isn't in there, add it in between the quotes. Then run (as root) mk_initrd re-boot I spit this out from memory.... someone else might see a flaw in it but it is a good bet that is the problem.