HI All, I am new to this list, and it`s great to have opportunity to participate here. I have to finish review of SuSE Linux 9.1 Pro for my magazine, but have a problem with USB function. Under SuSE 9.0 (I have wrote review too), my Flash disk is mounted something like this: /media/sda1/ but now mount point is something difficult to understand. Under SuSE 9.0, my USB Mass Storage digital camera usually is mounted like /media/sdb1/ and I was able to access pictures trough Konqueror. When I connect camera under SuSE 9.0, icon of hard disk appear on desktop, and I would mount it automaticly opening it. And only I need latter is to unmount. But now with SuSE 9.1 I have really problem with this same digital still camera. When I connect it, I don´t know for a way to access pictures. Obviously, it´s not mounted, but i can´t find which device is it now. Under SuSE 9.0 it was /dev/sbd1/ but now I am not sure. When I connect my USB Flash disk under SuSE 9.1, it´s mounted at point something like this: /media/usb-storage-004050098390:0:0:p1 but it works OK. But if I want to mount my USB Mass Storage Camera, how can I find where I need to mount it? All this numbers.... Anyway, my USB Mass Storage camera worked under SuSE 9.0, but now I don´t know what to do. I have tried command hwinfo, and system can see camera, here below is part of message I have got in terminal: 41: USB 00.0: 10600 Disk [Created at usb.120] Unique ID: cLrx.pg4fhkNS+GB Parent ID: k4bc.Z85BtXc5n8F SysFS ID: /devices/pci0000:00/0000:00:04.2/usb1/1-2/1-2:1.0 SysFS BusID: 1-2:1.0 Hardware Class: disk Model: "Fuji Photo Film USB Mass Storage" Hotplug: USB Vendor: usb 0x04cb "Fuji Photo Film Co., Ltd." Device: usb 0x011a "USB Mass Storage" Revision: "10.00" Serial ID: "Y-407^^^^^021002XFPX0003003497" Driver: "usb-storage" Speed: 1.5 Mbps Config Status: cfg=no, avail=yes, need=no, active=unknown Attached to: #39 (Hub) 42: USB 00.0: 10a00 Hub [Created at usb.120] Unique ID: pBe4.Kt9mEIPpjQ6 Parent ID: kmLG.WJLHWSpr11D SysFS ID: /devices/pci0000:00/0000:00:04.3/usb2/2-0:1.0 SysFS BusID: 2-0:1.0 Hardware Class: hub Model: "Linux 2.6.4-52-default uhci_hcd UHCI Host Controller" Hotplug: USB Vendor: "Linux 2.6.4-52-default uhci_hcd" Device: "UHCI Host Controller" Revision: "2.06" Serial ID: "0000:00:04.3" Driver: "hub" Speed: 1.5 Mbps Config Status: cfg=no, avail=yes, need=no, active=unknown Attached to: #19 (USB Controller) Please help me if you know how to mount it and access my camera. Anyway, all other USB hardware I have works very nice, USB Flash disk and external hard disk. I am very pleased with new SuSE 9.1, but this USB camera problem is big problem for now, and I need it very much (I am journalist, you know). Mirko Perak Belgrade