My system does not recognize any USB devices that are connected to it. I have a USB mouse and an All-in-one printer, an HP PSC 2175 model. I have already performed many of the steps in Suse Support articles in an effort to solve this issue. So far, I have had no success. I receive the following messages in /var/log/messages: Apr 13 21:04:06 linux syslogd 1.4.1: restart. Apr 13 21:04:07 linux /etc/hotplug/usb.rc[1141]: loaded HCD: ehci-hcd Apr 13 21:04:08 linux /etc/hotplug/usb.rc[1141]: loaded HCD: usb-ohci Apr 13 21:04:08 linux /etc/hotplug/usb.rc[1141]: loaded HCD: ehci-hcd Apr 13 21:04:11 linux kernel: klogd 1.4.1, log source = /proc/kmsg started. Apr 13 21:04:11 linux kernel: Inspecting /boot/System.map-2.4.20-4GB-athlon Apr 13 21:04:11 linux kernel: Loaded 20865 symbols from /boot/System.map-2.4.20-4GB-athlon. Apr 13 21:04:11 linux kernel: Symbols match kernel version 2.4.20. Apr 13 21:04:11 linux kernel: Loaded 560 symbols from 24 modules. Apr 13 21:04:11 linux kernel: PCI: Setting latency timer of device 00:06.0 to 64 Apr 13 21:04:11 linux kernel: intel8x0: clocking to 47377 Apr 13 21:04:11 linux kernel: Got silent jpeg. Apr 13 21:04:11 linux kernel: Got silent jpeg. Apr 13 21:04:11 linux kernel: Linux Tulip driver version 0.9.15-pre12 (Nov 11,
Apr 13 21:04:11 linux kernel: eth0: ADMtek Comet rev 17 at 0xa000, 00:04:5A:87:BC:F9, IRQ 5. Apr 13 21:04:11 linux kernel: 3c59x: Donald Becker and others. www.scyld.com/network/vortex.html Apr 13 21:04:11 linux kernel: See Documentation/networking/vortex.txt Apr 13 21:04:11 linux kernel: 03:01.0: 3Com PCI 3c920 Tornado at 0xc000. Vers LK1.1.16 Apr 13 21:04:11 linux kernel: 00:26:54:0b:f2:52, IRQ 11 Apr 13 21:04:11 linux kernel: product code ffff rev 00.0 date 15-31-127 Apr 13 21:04:11 linux kernel: Internal config register is 1600000,
Apr 13 21:04:11 linux kernel: 8K byte-wide RAM 5:3 Rx:Tx split, autoselect/MII interface. Apr 13 21:04:11 linux kernel: MII transceiver found at address 2, status
PRODUCT: SuSE Linux (I386) 8.2 2002) transceivers 0x40. 7849.
Apr 13 21:04:11 linux kernel: Enabling bus-master transmits and whole-frame receives. Apr 13 21:04:11 linux kernel: 03:01.0: scatter/gather enabled. h/w checksums enabled Apr 13 21:04:11 linux kernel: ohci1394: $Rev: 758 $ Ben Collins
Apr 13 21:04:11 linux kernel: PCI: Setting latency timer of device 00:0d.0 to 64 Apr 13 21:04:11 linux kernel: ohci1394_0: OHCI-1394 1.1 (PCI): IRQ=[5] MMIO=[e9086000-e90867ff] Max Packet=[2048] Apr 13 21:04:11 linux kernel: raw1394: /dev/raw1394 device initialized Apr 13 21:04:11 linux kernel: usb-uhci.c: $Revision: 1.275 $ time 16:04:20 Mar 12 2004 Apr 13 21:04:11 linux kernel: usb-uhci.c: High bandwidth mode enabled Apr 13 21:04:11 linux kernel: usb-uhci.c: v1.275:USB Universal Host Controller Interface driver Apr 13 21:04:11 linux kernel: uhci.c: USB Universal Host Controller Interface driver v1.1 Apr 13 21:04:11 linux kernel: PCI: Setting latency timer of device 00:02.0 to 64 Apr 13 21:04:11 linux kernel: usb-ohci.c: USB OHCI at membase 0xe48da000, IRQ 11 Apr 13 21:04:11 linux kernel: usb-ohci.c: usb-00:02.0, PCI device 10de:0067 (nVidia Corporation) Apr 13 21:04:11 linux kernel: usb.c: new USB bus registered, assigned bus number 2 Apr 13 21:04:11 linux kernel: hub.c: USB hub found Apr 13 21:04:11 linux kernel: hub.c: 3 ports detected Apr 13 21:04:11 linux kernel: PCI: Setting latency timer of device 00:02.1 to 64 Apr 13 21:04:11 linux kernel: usb-ohci.c: USB OHCI at membase 0xe48dc000, IRQ 10 Apr 13 21:04:11 linux kernel: usb-ohci.c: usb-00:02.1, PCI device 10de:0067 (nVidia Corporation) Apr 13 21:04:11 linux kernel: usb.c: new USB bus registered, assigned bus number 3 Apr 13 21:04:11 linux kernel: hub.c: USB hub found Apr 13 21:04:11 linux kernel: hub.c: 3 ports detected Apr 13 21:04:11 linux kernel: hub.c: new USB device 00:02.1-1, assigned address 2 Apr 13 21:04:12 linux kernel: Attached scsi CD-ROM sr0 at scsi1, channel 0, id 0, lun 0 Apr 13 21:04:12 linux kernel: sr0: scsi3-mmc drive: 40x/40x writer cd/rw xa/form2 cdda tray Apr 13 21:04:12 linux kernel: Uniform CD-ROM driver Revision: 3.12 Apr 13 21:04:13 linux kernel: usb_control/bulk_msg: timeout Apr 13 21:04:13 linux kernel: usb-ohci.c: unlink URB timeout Apr 13 21:04:13 linux kernel: usb.c: USB device not accepting new address=2 (error=-110) Apr 13 21:04:13 linux kernel: hub.c: new USB device 00:02.1-1, assigned address 3 Apr 13 21:04:18 linux kernel: usb_control/bulk_msg: timeout Apr 13 21:04:18 linux kernel: usb-ohci.c: unlink URB timeout Apr 13 21:04:18 linux kernel: usb.c: USB device not accepting new address=3 (error=-110) Apr 13 21:04:19 linux kernel: mice: PS/2 mouse device common for all mice Apr 13 21:04:25 linux kernel: spurious 8259A interrupt: IRQ7. Apr 13 21:04:26 linux kernel: isapnp: Scanning for PnP cards... Apr 13 21:04:26 linux kernel: isapnp: No Plug & Play device found Apr 13 21:04:29 linux kernel: IPv6 v0.8 for NET4.0 Apr 13 21:04:29 linux kernel: IPv6 over IPv4 tunneling driver Apr 13 21:04:29 linux sshd[1677]: Server listening on :: port 22. Apr 13 21:04:31 linux /usr/sbin/cron[1893]: (CRON) STARTUP (fork ok) Apr 13 21:04:34 linux kernel: Linux video capture interface: v1.00 Apr 13 21:04:37 linux /etc/hotplug/net.agent[1714]: No HW description found ... exiting Apr 13 21:04:39 linux kernel: parport0: PC-style at 0x378 (0x778) [PCSPP,TRISTATE] Apr 13 21:04:39 linux kernel: parport0: irq 7 detected Apr 13 21:04:39 linux kernel: lp0: using parport0 (polling). Apr 13 21:04:39 linux kernel: usb.c: registered new driver serial Apr 13 21:04:39 linux kernel: usbserial.c: USB Serial support registered for Generic Apr 13 21:04:39 linux kernel: usbserial.c: USB Serial Driver core v1.4 Apr 13 21:05:04 linux kdm[1945]: pam_unix2: session started for user root, service xdm Apr 13 21:05:04 linux resmgr[1548]: accepted connection from user root Apr 13 21:05:04 linux resmgr[1548]: disconnect from root The 'timeout' messages seem to be the issue. As mentioned before, I have performed the steps in Suse Support articles to try to address the issue.
Thanks in advance, Corey