Hi all... On Thursday 26 February 2004 19:05, expatriate wrote:
James Hatridge wrote:
Hi all...
I've got a hub and the transformer burned up. So as a replacement I got the type that has multi-value for the volts, ie from 0 to 12v. My hub uses 5v, but the transformer has only 4.5 and 6v. I put the dial about between the two. It works, but is this good? It also works when I set it at 6v, but could this be too much? Any ideas?
Thanks
JIM
Try it on 4.5. If it works, leave it there. Are you sure that the knob does vary the voltage continuously between the 4.5 and 6.0 setting? If it does, the middle is OK. 6V is probably OK too, just feel the hub and see if it gets too warm.
How did the old transformer burn up? Too much load on it?
I guess so... I use it for my 8 node 'wulf. When I have all 8 nodes going at speed the hub is more than hand warm. BTW it's a D-Link DSH-8 hub. A few days ago I had only a couple of the nodes up and running, just moving some files around no big thing. I went outside to get the mail etc. Came back inside and could smell that burning plasic smell. I'm sure everyone here knows it. I looked around and the transformer brick looked like it was designed by Dali. <G> Anyway I'm stuck with this hub until I can score a switch. BTW does anyone have an old usable 8 to 16 node switch laying around? I could go up to 10$ plus postage for a usable one. Thanks, JIM -- Jim Hatridge Linux User #88484 ------------------------------------------------------ BayerWulf Linux System # 129656 The Recycled Beowulf Project Looking for throw-away or obsolete computers and parts to recycle into a Linux super computer WartHog Bulletin Info about new German Stamps http://www.fuzzybunnymilitia.org/~hatridge/bulletin Viel Feind -- Viel Ehr' Anti-US Propaganda stamp collection http://www.fuzzybunnymilitia.org/~hatridge/collection