6 Sep
2003
6 Sep
'03
14:06
VERY new to Linux and SuSE. SuSE 8.2 i386 purchased Trying to install EG1032 network card. Card is identified as a NS82030 (I think that's right) and that driver is loaded (is that the right term?). There is an onboard NIC (eth0) as well that I have yet to get disabled (jumper on the board somewhere). It works fine. If I plug the network cable into the EG1032 it gets an IP address during boot but I cannot connect to the internet. I have read on other groups that the NS82030 driver works in SuSE (not sure of the build) but I'm not having any luck. Are there some standard settings I can try? And how would I make them and/or where would I find the info. Thanks Mark B