I am thoroughly disgusted with this situation. I have an 8.0 system. It runs fine, if a bit slower than previous versions. The one thing that is making me crazy is printing. I had different printing problems with 7.3 too, 7.1 was fine. I have an HP IIP laser, it prints perfectly under Win98. Under linux I am using lprng sosftware. The problem is it USUALLY prints too close to the top of the paper so the top line is cut in half. I have gone through everything I can think of to correct or modify the system to no avail. No my software is NOT set to A4 it is set to letter. I even went into the lpdfilter and hard modified it so wherever it referred to a paper size it would come up letter. This really is ridiculous. Under previous versions of Suse there was a program for Tex called texconfig that had a section that allowed you to move the area of printing around until it was symmetrical (they have taken that out, as far as I could tell, when they changed texconfig), THAT is what it seems like I need. I have checked the manual for the printer and there is no way to make margin settings THERE. Printing is IMPORTANT. There HAS to be a solution for this so I am willing to do whatever. Please don't say that CUPS is the answer, if it was that good Suse would have made it the default and they didn't. I tried CUPS on 7.3 and it was just as bad, I also tried the commercial package, whose name I forget, ESP maybe? I sure could use a hand here. I have RTFM and wouldn't be asking if I had found an answer. Scott