Hi everyone, I need some help to compile my ppp. The eason is i insalled Eric Young's Des library (libdes-4.01.tar) for MS Authentication problems. The Des library installed to the following path " /usr/local/lib " as it said on the kppp' .Now Eric Young's Des library is under "/usr/local/lib" The problem is i am new to linux. And i don't know how to compile kppp Can anyone write me the full command for compiling kppp. Readme.MSCHAP80 Now the followin section need to be done. [You "I" should now be ready to (re)compile the PPPD.????? Go to the pppd subdirectory ????and make sure the Makefile contains "-DCHAPMS" in the CFLAGS or COMPILE_FLAGS macro, and that the LIBS macro (or LDADD for BSD systems) contains "-ldes". Depending on your system and where the DES library was installed, you may also need to alter the include and library paths used by your compiler.] 1- how can i compile and where? ie: shell, ? 2-is there any path that i need to follow? If i am not wrong my "ppp" is on "etc/ppp/" 3-how can i go to the "kppp sub directory" and where? 4- Are these file or line " "-DCHAPMS" in the CFLAGS or COMPILE_FLAGS macro, and that the LIBS macro" Do a "make clean" ????and then a "make" ????to rebuild ???? pppd. Assuming all goes well, install ????the new pppd and move on to the CONFIGURATION section. On this part as it says i need to "make clean" and then " make". again 1- Where could i make " make clean"and "make" because i just wrote these command on the shell and it was sayin no target specified. How i can write the full command? (make clean " target" )? and again same question how and where could i make the "make" command in order to rebuild the pppd.? P.S. I am trying to use SuSE 7.2 pro. Kernel is 2.4.4 GB My computer is Compaq 1800T Notebook. Any help appreciated in advance emin