2 Sep
2001
2 Sep
'01
18:03
On Sunday 02 September 2001 4:39 pm, emanon wrote:
sometimes as a monitor gets old you have to adjust the ferrite slug in the flyback transformer. monitors used to have an access hole in the back where you could insert an alignment tool (plastic screwdriver). now you have to take the case off. usually once this happens you can figure that your monitor is near the end of it's service life.
Do this with *caution* since there are *very* high voltages present in a monitor/CRT even after the power has been disconnected for some time. If you don't know what you're doing don't attempt anything like this. M