On Sunday 02 September 2001 1:07 pm, Chris Herrnberger wrote:
Greetings all.
Last night a friend asked me to pull some data off an old Mac driver ( Conner 128 meg). So follwoing the thread on scsi support raised by Dee W. I figured i would give this a try. Not having used scsi in a very long time, I dug up an old adaptec 1542c isa card and proceeded with the installation.
After approx an hour I had the mac drive being recognized by the card (totally misconfigured) and got the bios loaded signal from the scsi bios reporting sequence. Next linux loaded as usual.
However doing an insmod aha1542 gives me the following error root@gunnel:/home/chris > insmod aha1542 Using /lib/modules/2.4.4-4GB/kernel/drivers/scsi/aha1542.o /lib/modules/2.4.4-4GB/kernel/drivers/scsi/aha1542.o: unresolved symbol isapnp_find_dev
now dmesg is informative after running modprobe aha1542
Configuring Adaptec (SCSI-ID 7) at IO:330, IRQ 11, DMA priority 0 aha1542.c: Using extended bios translation scsi0 : Adaptec 1542 aha1542.c: Unable to abort command for target 0 aha1542.c: Trying device reset for target 0 aha1542.c: Unable to abort command for target 0 Sent BUS RESET to scsi host 0 aha1542.c: Unable to abort command for target 0 scsi: device set offline - not ready or command retry failed after host reset: host 0 channel 0 id 0 lun 0 Vendor: CONNER Model: CP30175E-170Mb Rev: 5.23 Type: Direct-Access ANSI SCSI revision: 01 CCS Detected scsi disk sda at scsi0, channel 0, id 0, lun 0 aha1542.c: Unable to abort command for target 0 aha1542.c: Trying device reset for target 0 aha1542.c: Unable to abort command for target 0 Sent BUS RESET to scsi host 0 aha1542.c: Unable to abort command for target 0 scsi: device set offline - not ready or command retry failed after host reset: host 0 channel 0 id 0 lun 1 aha1542.c: Unable to abort command for target 1 aha1542.c: Trying device reset for target 1 aha1542.c: Unable to abort command for target 1 Sent BUS RESET to scsi host 0 aha1542.c: Unable to abort command for target 1 scsi: device set offline - not ready or command retry failed after host reset: host 0 channel 0 id 1 lun 0 aha1542.c: Unable to abort command for target 2 aha1542.c: Trying device reset for target 2 aha1542.c: Unable to abort command for target 2 Sent BUS RESET to scsi host 0 aha1542.c: Unable to abort command for target 2 scsi: device set offline - not ready or command retry failed after host reset: host 0 channel 0 id 2 lun 0 aha1542.c: Unable to abort command for target 3 aha1542.c: Trying device reset for target 3 aha1542.c: Unable to abort command for target 3 \ and this continues through to target 6 So my question is how do I address the unresolved symbol issue?
Did you type insmod aha1542=0x330? M