"Peter B. Van Campen" wrote:
Just rcvd 7.1 Prof. Started a fresh install with YAST2. Just after the point where YAST2 asks which brand and model of monitor (it found and identified my Elsa Office Winner 2000 8-Meg) (Viewsonic 17ps) it requested my choice of resolution and color depth I chose 1152 x 864 at 24 bits; YAST2 then put up a test screen which was ok,but off-center. I adjusted its position and size and entered a "OK". At that point the monitor went into standby mode. The system has remained active ( drive activity) but the monitor has not come back on;
How can I recover this YAST2 installation?
Hi Peter, I had a somwhat similar problem during my upgrade to 7.1. I was able to get to a virual console by typing Ctrl-Alt-F1 and continue the installation from there. Richard -- << "If the future's looking dark, we're the ones who have to shine." >> -- Neil Peart ---***---***---***---***---***---***---***---***---***---***---***--- Richard Witt Phone: (330) 672-0096 Dept. of Physics, Kent State University Email: witt@cnr2.kent.edu ---***---***---***---***---***---***---***---***---***---***---***---