Message-ID: <007401c0682c$a73e46a0$0100a8c0@9>
From: "Dennis"
Date: Sun, 17 Dec 2000 21:24:15 +0800
Subject: Re: [SLE] Microsoft Wheel mouse
All right, I finally got it to work. :)
And many thanks to Szucs, pointing out that the changes should be in /etc/X11/XF86Config instead of /etc/XF86Config.
This is confusing and causes all the delay on getting it to work earlier.
Rgds.
Dennis
@Singapore
----- Original Message -----
From: Szûcs Dénes
To: Dennis
Sent: Saturday, 16 December, 2000 7:47 PM
Subject: Re: [SLE] Microsoft Wheel mouse
<p> Hi!
I had the same problem. Had to modify the solution found on the Suse web page a little bit:
modifying the config file in /etc/X11/XF86Config worked:
Section "InputDevice"
Driver "mouse"
Identifier "Mouse[1]"
Option "Device" "/dev/pointer0"
Option "Protocol" "IMPS/2"
Option "SampleRate" "60"
Option "BaudRate" "1200"
Option "ZAxisMapping" "4 5"
Option "Buttons" "3"
Dennis wrote:
Tried many times, but no luck so far, any further advise is appreciated.ThanksDennis@Singapore
http://sdb.suse.de/sdb/en/html/lmarks_imwheel_setup.htmlDavid,Please read the above article. It tells you in detail how to getthis to work...Regards,* david.herbison@hl.siemens.de (david.herbison@hl.siemens.de) [001212
01:34]:
-**-Hi all,-**--**-I can't seem to get a Microsoft wheel mouse to work under 6.4, at
least
-**-the middle button support. It's not an Intellimouse. Anyone got any-**-suggestions?--Ben Rosenberg mailto:brosenb@suse.com***************************************SuSE Inc.580 Second St Suite 210Oakland CA 94607 U.S.ATel: 1-510-628-3380 EXT:5086Fax: 1-510-628-3381***************************************"My opinions are not a reflection of the opinions of SuSE Inc."--To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.comFor additional commands send e-mail to suse-linux-e-help@suse.comAlso check the FAQ at http://www.suse.com/support/faq
!
