From the x3d collection install the rivaglx package. Then read the documents in /usr/doc/packages/riva-something-or-other (I forget the
Hi, ** 1) Ok I compile my custom kernel make dep, clean, modules, modules_install...blah blah ** blah and all this bull**** ** ok then when I boot it boots normaly until to the point where it says...checking modules ** dependencies...well and there is stops. What happens is the hard disk stops and I have ** to press Ctrl-C to skip the dependency check and move to another task. When I do that it ** continues normaly but the x-server does not load. I can only login on text mode. ** What gives? Is it some module dependency probelmo? When I do depmod -a -e it say quite a ** lot of modules have some kinda of inconsistency....why?? what can I do? Why the hell do you need to compile the kernel? Check /etc/modules.conf and load the ones you need. Between, firewall, clients and servers, all the systems I've built have a stock kernel as provided with the req'd modules. Personally, RTFM mate. ** 2) Questiona numero dos....I have a 3d card with the NVidia TNT2 chip on it. Could I use ** this to play GLQuake? if not could I use it as a doorstop? dir). You load the module into the X server, then it works. HtH ----------------------------------------------------------- Chris Smith IS Dept - Raytheon Systems Limited [chris.smith@raytheon.co.uk] +44 1279 407 103 ----------------------------------------------------------- Programmers are busy writing the next best idiot proof software. The universe, in the meantine, is busy making the next best idiot. The universe is winning... =========================================================== -- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/Support/Doku/FAQ/