Hi there, I just compiled, installed and configured emu10k1 (for a SoundBlaster Live! card) and did $ modprobe emu10k1 The control panel says No information available or This system is not yet supported $ lsmod has the following result: Module Size Used by emu10k1 40784 0 (unused) soundcore 2148 4 [emu10k1] ide-scsi 7052 1 (autoclean) sr_mod 17672 1 (autoclean) cdrom 13336 0 (autoclean) [sr_mod] scsi_mod 37516 2 (autoclean) [ide-scsi sr_mod] ppp_deflate 40548 0 (autoclean) bsd_comp 3632 0 (autoclean) ppp 19948 2 (autoclean) [ppp_deflate bsd_comp] slhc 4268 0 (autoclean) [ppp] serial 18452 1 (autoclean) nls_iso8859-1 2020 1 (autoclean) nls_cp437 3548 1 (autoclean) vfat 9116 1 (autoclean) fat 29952 1 (autoclean) [vfat] $ lspci has the following result: 00:00.0 Host bridge: Intel Corporation 440BX/ZX - 82443BX/ZX Host bridge (rev 02) 00:01.0 PCI bridge: Intel Corporation 440BX/ZX - 82443BX/ZX AGP bridge (rev 02) 00:07.0 ISA bridge: Intel Corporation 82371AB PIIX4 ISA (rev 02) 00:07.1 IDE interface: Intel Corporation 82371AB PIIX4 IDE (rev 01) 00:07.2 USB Controller: Intel Corporation 82371AB PIIX4 USB (rev 01) 00:07.3 Bridge: Intel Corporation 82371AB PIIX4 ACPI (rev 02) 00:09.0 Multimedia audio controller: Creative Labs SB Live! (rev 04) 00:09.1 Input device controller: Creative Labs SB Live! Daughterboard (rev 01 When I insert a CD the CD player (KSCD) just acts as if there's no CD - it says 'ejected' However, when I press on the manual play button the CD plays fine, although KSCD still acts as if there's no CD loaded. Is there something I may have overlooked? Thanks. -- Yatsen Ng yatsenng@casema.net It said "Needs Windows 98 or better." So I installed Linux... -- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/Support/Doku/FAQ/