Greetings to all, I have just purchased and installed 6.4 on my IBM Thinkpad 770X. My PCMCIA network adapter is the IBM 10/100 Etherjet Cardbus card. When the unit is in the docking station, it boots just fine; identifies the card with no errors. When I remove the laptop from the docking station, the boot will hang: total lockup. The only way to boot is to remove the card. This is a portion of the boot process where the hang appears to occur: cardmgr[70]: watching 2 sockets cardmgr[70]: initializing socket 0 cardmgr[70]: socket 0: IBM Etherjet Cardbus cardmgr[70]: executing: 'insmod /lib/modules/2.2.14/pcmcia/cb_enabler.o' cardmgr[70]: executing: 'insmod /lib/modules/2.2.14/pcmcia/tulip_cb.o' This does not happen when docked. I thought IRQ issue, but can't figure out why the difference: this card normally occupies IRQ 10 in OS/2 and WinNT, fwiw. I am still relatively new to SuSE and Linux so any pointers would be helpful. Under 6.2 I had no luck with this card. 6.3 handled it with no problems. 6.4 is the best distribution yet, but this one has me scratching my head. TIA and TYK! Bill Fullam Xerox Connect -- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/Support/Doku/FAQ/