Gentlemen I need your help. I'm a home user and most of your discussions are over my head but I'm trying to learn. Will anyone condescent to help me figure out why I can't print anything from anywhere with my SuSe 6.1 installation? I have installed and adjusted and deleted the whole thing about a million times now and I can't think of anything else to adjust or configure. It's just me, no network, nothing fancy and my box runs it beautifully and I love it, but I can't print anything, ever. Well, one install once printed a test page with Kedit but after adding a few packages it was gone again. The current incarnation shows a module for lp.0. insmod lp Using /lib/modules/2.2.5/misc/lp.0 insmod: a module named lp already exists is this what it's supposed to say? Apsfilter is set up through Yast. I've tried it with the /etc/ppp/apsfilter as well as using many different configs with two different printers. Can't figure out what I could do with printcap so I've always left that alone. I even tried texconfig though it doesn't seem to have any effect. Does it matter, how does it matter, how network configs are set? I've tried lots of scenerios there too. Anyone care to help a tech-challenged, frustrated home user? David __________________________________________________ Do You Yahoo!? Talk to your friends online with Yahoo! Messenger. http://im.yahoo.com -- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/Support/Doku/FAQ/