openSUSE Recommended Update: Recommended update for dracut ______________________________________________________________________________ Announcement ID: openSUSE-RU-2017:0284-1 Rating: low References: #1007648 #915218 #995812 #998440 Affected Products: openSUSE Leap 42.2 ______________________________________________________________________________ An update that has four recommended fixes can now be installed. Description: This update for dracut provides the following fixes: - Set persistent policy to by-path on s390 platforms to prevent the system from hanging during boot when vDISKs are used as swap devices. (bsc#915218) - Correctly handle incomplete ibft bootflag settings. (bsc#1007648) - Do not pass ifname for bonding devices. (bsc#995812) - Always try to load the pinctrl-cherryview kernel module. (bsc#998440) This update was imported from the SUSE:SLE-12-SP2:Update update project. Patch Instructions: To install this openSUSE Recommended Update use YaST online_update. Alternatively you can run the command listed for your product: - openSUSE Leap 42.2: zypper in -t patch openSUSE-2017-146=1 To bring your system up-to-date, use "zypper patch". Package List: - openSUSE Leap 42.2 (i586 x86_64): dracut-044-14.1 dracut-debuginfo-044-14.1 dracut-debugsource-044-14.1 dracut-fips-044-14.1 dracut-tools-044-14.1 References: https://bugzilla.suse.com/1007648 https://bugzilla.suse.com/915218 https://bugzilla.suse.com/995812 https://bugzilla.suse.com/998440