Hi here my experience in getting Factory 0003 build installed on pmac_new G5.
On Sat, Feb 18, 2012 at 10:47 PM, Wolfgang Engel
Hi there,
just a few words how to boot current factory on PowerMac. I tried it on a 1,6GHz PowerMac G5.
1. Power on your PowerMac ;) 2. Get to Open Firmware with "Alt-Option-O-F" keys pressed 3. Insert openSUSE-NET-ppc CD by ejecting CD-ROM drive with command "eject cd" 4. Boot into yaboot by entering "boot cd:,\suseboot\yaboot" 5. Choose your Installation-Type
From there I was able to go through installation pre-configuration setup (network, http-server) and YaST2 started. But it crashed when I tried to do partitioning stuff. It didn't crashed for me. Maybe I'm using newer yast build.
The lilo.conf generated by perl-Bootloader is wrong. It writes to the option section: append initrd root You need to configure installation in a way it start a shell before and after installation. (So after installation you can debug booloader) So I've deleted those bad strings and rerun lilo. It wrote yaboot configuration to the disk. But still have an error like: MAC-PARTS: specified partiition is not valid /ht@0,f2000000/pci@5/k2-sata-root@c/k2-sata@0/disk@0:4,/boot/vmlinux-3.2.0-5-ppc64: Unable to open file, Invalid device Also I've found that perl-Bootloader reports missing submodule powerlilo that might cause issue. Have fun,
Maybe someday I'll have the knowledge to be able to fix things for PPC...
Have fun!
Wolfgang
-- View this message in context: http://opensuse.14.n6.nabble.com/Booting-openSUSE-NET-ppc-Build0003-Media-is... Sent from the opensuse-ppc mailing list archive at Nabble.com. -- To unsubscribe, e-mail: opensuse-ppc+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse-ppc+owner@opensuse.org
-- To unsubscribe, e-mail: opensuse-ppc+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse-ppc+owner@opensuse.org