Hallo Stefan,
On Mon, Jul 05, 2004 at 03:35:50PM +0200, gregor willms wrote:
/usr/share/doc/packages/powersave/LIESMICH.suspend.
habe ich schon mal gemacht, o.k.
gut :-)
Was ist das für ein Modem (welches Modul)?
YAST-Hardware-Info gibt aus: Smartlink Softmodem Treiber: slamr
ok, versuche mal "slmodemd" in POWERSAVE_SUSPEND_RESTART_SERVICES in /etc/sysconfig/powersave/common einzufügen (in die Variable). Dann wird vor dem suspend ein "/etc/init.d/slmodemd stop" und nach dem resume ein "/etc/init.d/slmodemd start" gemacht. Dabei wird auch das Modul entladen und neu geladen.
ich hoffe, du hälst mich jetzt für keinen Dummkopf, ich bin allerdings ziemlicher Linux-Neuling. Ich habe "slmodemd" in verschiedener Weise in "POWERSAVE_SUSPEND_RESTART_SERVICES" eingefügt. Vielleicht habe ich das nicht richtig bewerkstelligt, jedenfalls hat sic nichts getan. Ich habe es auf zwei verschiedene Weisen versucht. POWERSAVE_SUSPEND_RESTART_SERVICES="hotplug slmodemd " und POWERSAVE_SUSPEND_RESTART_SERVICES="hotplug" "slmodemd" scheint sich aber überhaupt nichts verändert zu haben; ich bin, wie gesagt, ziemlich neu bei linux, falls ich da an der syntax oder sonstwie etwas falsch eingegeben habe, würde ich mich freuen, wenn du mich korrigieren könntest. Ich habe die /var/log/messages am Ende nochmal eingefügt; hat sich das modem-modul denn überhaupt entladen?
Wenn es danach geht, ist es gut. Wenn nicht, stehen die Chancen schlecht.
ich hoffe, du kannst damit was anfangen, würde mich freuen
Ja, der interessante Teil war zwischen "Stopping Tasks..." und den Meldungen des pppd. Dummerweise sagt das Modem-Modul gar nichts zum suspend und resume... Hoffen wir, daß entladen und neu laden hilft. -- Stefan Seyfried
hier noch die var/log/messages
Jul 6 13:21:49 linux kernel: ehci_hcd 0000:00:1d.7: remove, state 1
Jul 6 13:21:49 linux kernel: usb usb4: USB disconnect, address 1
Jul 6 13:21:49 linux kernel: ehci_hcd 0000:00:1d.7: USB bus 4 deregistered
Jul 6 13:21:49 linux kernel: nodemgr: Exiting due to no down
Jul 6 13:21:49 linux kernel: ieee1394: Node removed: ID:BUS[0-00:1023]
GUID[00023f4244007565]
Jul 6 13:21:49 linux /sbin/hotplug-stopped[0]: hotplugging not enabled. Run
rchotplug start
Jul 6 13:21:49 linux last message repeated 5 times
Jul 6 13:21:49 linux [powersave_proxy][6316]: WARNING: Modules unloaded
Jul 6 13:21:49 linux /sbin/hotplug-stopped[0]: hotplugging not enabled. Run
rchotplug start
Jul 6 13:21:49 linux last message repeated 2 times
Jul 6 13:21:49 linux kernel: SFW2-OUT-IPv6_PROHIB IN= OUT=eth1
SRC=0000:0000:0000:0000:0000:0000:0000:0000
DST=ff02:0000:0000:0000:0000:0000:0000:0002 LEN=72 TC=0 HOPLIMIT=1 FLOWLBL=0
PROTO=0
Jul 6 13:21:49 linux /sbin/hotplug-stopped[0]: hotplugging not enabled. Run
rchotplug start
Jul 6 13:21:49 linux dhcpcd[3225]: recvfrom: Network is down
Jul 6 13:21:49 linux dhcpcd[3225]: dhcpStop: ioctl SIOCSIFADDR: No such
device
Jul 6 13:21:49 linux dhcpcd[3225]: dhcpStop: ioctl SIOCSIFFLAGS: No such
device
Jul 6 13:21:49 linux dhcpcd-hook: Skipping 'ifdown $INTERFACE -o dhcp' call
Jul 6 13:22:45 linux kernel: Stopping tasks:
============================================================|
Jul 6 13:22:45 linux kernel: Freeing memory: .......|
Jul 6 13:22:45 linux kernel: ..|
Jul 6 13:22:45 linux kernel: .|
Jul 6 13:22:45 linux last message repeated 2 times
Jul 6 13:22:45 linux kernel: /critical section: Handling highmem
Jul 6 13:22:45 linux kernel: counting pages to copy.....[nosave c038c000]
[nosave c038d000][nosave
c038e000]...................................................................................................................................................................
Jul 6 13:22:45 linux kernel: (pages needed: 8935+512=9447 free: 118022)
Jul 6 13:22:45 linux kernel: Alloc pagedir
Jul 6 13:22:45 linux kernel: .....[nosave c038c000][nosave c038d000][nosave
c038e000]Freeing prev allocated pagedir
Jul 6 13:22:45 linux kernel: Restoring highmem
Jul 6 13:22:46 linux [powersaved][4758]: WARNING in Function start; line 387:
Select returned an Error, but not interrupted through a signal: Success! This
is not nice, but normal after a suspend!
Jul 6 13:22:45 linux kernel: done, devices
Jul 6 13:22:46 linux kernel: PCI: Setting latency timer of device
0000:00:1d.0 to 64
Jul 6 13:22:46 linux kernel: PCI: Setting latency timer of device
0000:00:1d.1 to 64
Jul 6 13:22:46 linux kernel: PCI: Setting latency timer of device
0000:00:1d.2 to 64
Jul 6 13:22:46 linux kernel: PCI: Setting latency timer of device
0000:00:1d.7 to 64
Jul 6 13:22:46 linux kernel: PCI: Setting latency timer of device
0000:00:1f.5 to 64
Jul 6 13:22:46 linux kernel: PCI: Setting latency timer of device
0000:00:1f.6 to 64
Jul 6 13:22:46 linux kernel: eth0: link down
Jul 6 13:22:46 linux kernel: Fixing swap signatures... ok
Jul 6 13:22:46 linux kernel: Restarting tasks... done
Jul 6 13:22:46 linux kernel: usb 3-2: USB disconnect, address 3
Jul 6 13:22:46 linux kernel: usb 3-2: new low speed USB device using address
4
Jul 6 13:22:46 linux kernel: usb 3-2: Product: USB Mouse
Jul 6 13:22:46 linux kernel: usb 3-2: Manufacturer: Logitech
Jul 6 13:22:46 linux kernel: input: USB HID v1.10 Mouse [Logitech USB Mouse]
on usb-0000:00:1d.2-2
Jul 6 13:22:48 linux /sbin/hotplug-stopped[0]: hotplugging not enabled. Run
rchotplug start
Jul 6 13:22:48 linux last message repeated 9 times
Jul 6 13:22:52 linux kernel: ipw2100: Intel(R) PRO/Wireless 2100 Network
Driver, 0.42
Jul 6 13:22:52 linux kernel: ipw2100: Copyright(c) 2003-2004 Intel
Corporation
Jul 6 13:22:52 linux kernel: Detected ipw2100 PCI device at 0000:01:02.0,
dev: eth1, mem: 0xE0000000-0xE0000FFF -> e0801000, irq: 10
Jul 6 13:22:52 linux kernel: eth1: Using hotplug firmware load.
Jul 6 13:22:52 linux /sbin/hotplug-stopped[0]: hotplugging not enabled. Run
rchotplug start
Jul 6 13:22:52 linux /sbin/hotplug-stopped[0]: hotplugging not enabled. Run
rchotplug start
Jul 6 13:23:02 linux kernel: eth1: Firmware not available or load failed
Jul 6 13:23:02 linux kernel: eth1: ipw2100_get_firmware failed: -2
Jul 6 13:23:02 linux kernel: eth1: Failed to power on the adapter.
Jul 6 13:23:02 linux kernel: eth1: Failed to start the firmware.
Jul 6 13:23:02 linux /sbin/hotplug-stopped[0]: hotplugging not enabled. Run
rchotplug start
Jul 6 13:23:02 linux /sbin/hotplug-stopped[0]: hotplugging not enabled. Run
rchotplug start
Jul 6 13:23:02 linux kernel: ipw2100: probe of 0000:01:02.0 failed with error
-5
Jul 6 13:23:02 linux kernel: ieee1394: Initialized config rom entry `ip1394'
Jul 6 13:23:02 linux /sbin/hotplug-stopped[0]: hotplugging not enabled. Run
rchotplug start
Jul 6 13:23:02 linux kernel: ohci1394: $Rev: 1203 $ Ben Collins