Is one supposed to override the other in 13.1? In 13.2? If so, which is supposed to take precedence? Before allowing latest kernel to be installed via zypper dup, I appended omit_drivers+="sata_sil" to /etc/dracut.conf as this is what line 29 of the dracut.conf man page seemed to say I needed to ensure that sata_sil would not load via initrd. Yet after including it and proceeding to install the new kernel, sata_sil was included in the new initrd anyway (which puts / on sdbX instead of sdaX as it was at installation time). Why was sata_sil included in INITRD_MODULES in /etc/sysconfig.kernel in the first place? The accessory (PCI) SiI 3512 hardware controller had no attached devices during openSUSE installation. When I do attach something to an eSATA port, it's always a data disk. My boot disks are always internal, same as most systems, and particularly laptops. -- "The wise are known for their understanding, and pleasant words are persuasive." Proverbs 16:21 (New Living Translation) Team OS/2 ** Reg. Linux User #211409 ** a11y rocks! Felix Miata *** http://fm.no-ip.com/ -- To unsubscribe, e-mail: opensuse-kernel+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse-kernel+owner@opensuse.org