Mailinglist Archive: opensuse-factory (533 mails)

< Previous Next >
Re: [opensuse-factory] Netiso MS3: Not all needed modules present in repo.
  • From: "Rajko M." <rmatov101@xxxxxxxxxxx>
  • Date: Mon, 12 Apr 2010 18:57:29 -0500
  • Message-id: <201004121857.29318.rmatov101@xxxxxxxxxxx>
On Monday 12 April 2010 13:34:51 Oddball wrote:
Oddball schreef:
AMD64x2-sfn1:/home/oddball # uname -r
AMD64x2-sfn1:/home/oddball # grep -i ext4 /boot/config-`uname -r`
AMD64x2-sfn1:/home/oddball # modprobe --list ext4dev
AMD64x2-sfn1:/home/oddball # modprobe -v ext4dev
insmod /lib/modules/
insmod /lib/modules/
insmod /lib/modules/
AMD64x2-sfn1:/home/oddball #

There is no complain from modprobe and that means the driver is loaded.

I would recommend to check is driver really loaded after modprobe or it is
crashing later when you try to use it.

Right after the
modprobe -v ext4dev
lsmod | grep -i ext4
to see is driver loaded.

Then if you see the driver try to mount hard disk:
mount /dev/sda11 /mnt
and then run again:
lsmod | grep -i ext4
to see is driver still in place.

If it is, then try to see content.
If you can't then run again:
lsmod | grep -i ext4

As mentioned I used it and it worked fine.
The main difference, so far I recall, is that I don't have so many partitions.

If you see kernel update from regular update repo then do it, but make sure
that zypper will keep old kernel. Set option:
multiversion = kernel-default
in /etc/zypp/zypp.conf which will preserve your old kernel, and make possible
to boot the old one, if new fails.

Regards Rajko,
To unsubscribe, e-mail: opensuse-factory+unsubscribe@xxxxxxxxxxxx
For additional commands, e-mail: opensuse-factory+help@xxxxxxxxxxxx

< Previous Next >
Follow Ups