Mailinglist Archive: opensuse-factory (549 mails)

< Previous Next >
Re: [opensuse-factory] ./configure Permission Denied
  • From: Donn Washburn <n5xwb@xxxxxxxxxxx>
  • Date: Tue, 24 Nov 2009 07:35:50 -0600
  • Message-id: <4B0BE136.3070504@xxxxxxxxxxx>
On 11/24/2009 04:53 AM, Marcus Meissner wrote:
On Mon, Nov 23, 2009 at 09:25:52PM -0600, Donn Washburn wrote:

Hey Group;

Do I need to replace bash to solve the problem with every source not
allowing ./configure to run.
Try a source with a ./configure script and every one of them give a
"Permission Denied". This is a RC2 problem never seen before from a SuSE
version from way back 5 or 6. I must assume this is just any over
site. Please fix it.

Or is it necessary to look elsewhere for a Linux distribution lacking a
defective bash, syslinux and/or fuse.
bash version is "bash-4.0.19-5-i586",

This is a very irritating problem. This complaint comes from "-bash:".
as "-bash: ./configure Permission Denied"

Well, is the configure script not marked executable?
Or Is the filesystem perhaps marked as "noexec"?

Ciao, Marcus

No Sir! I even as a test set all of the files to 777 and it fails.

Also here is a strace conf.err output. It is short

You may have found it!!!!

/etc/fstab shows sdc1 as clear of noexec but /etc/mtab shows it. Where
does mtab get its information?

73 de Donn Washburn
307 Savoy Street Email:" n5xwb@xxxxxxxxxxx "
Sugar Land, TX 77478 LL#
Ham Callsign N5XWB HAMs : " n5xwb@xxxxxxxx "
VoIP via Gizmo: bmw_87kbike / via Skype: n5xwbg
BMW MOA #: 4146 - Ambassador
" " #279316

execve("./configure", ["./configure"], [/* 59 vars */]) = -1 EACCES (Permission
dup(2) = 3
fcntl64(3, F_GETFL) = 0x8002 (flags O_RDWR|O_LARGEFILE)
fstat64(3, {st_mode=S_IFCHR|0620, st_rdev=makedev(4, 1), ...}) = 0
ioctl(3, SNDCTL_TMR_TIMEBASE or TCGETS, {B38400 opost isig icanon echo ...}) = 0
_llseek(3, 0, 0xbf882d80, SEEK_CUR) = -1 ESPIPE (Illegal seek)
write(3, "strace: exec: Permission denied\n", 32) = 32
close(3) = 0
munmap(0xb7721000, 4096) = 0
< Previous Next >
Follow Ups