El 2004-06-04 a las 09:07 +0200, SioM escribió:
El error que da es GRUB Hard Disk Error He probado con LILO (dejando la configuración que da SUSE por defecto, y editando lilo.conf (siguiendo la ayuda de lilo) y en lugar de ese error me sale L 01 01 01 ...... (muchos 01) y se queda ahí parado. Vuelvo a poner como tengo las particiones hechas, co los tamaños tambien por si tiene algo que ver:
Me sospecho que tu primer disco es demasiado grande. Prueba a arrancar desde el segundo disco (desde la bios), e instala grub allí. When LILO loads itself, it displays the word "LILO". Each letter is printed before or after performing some specific action. If LILO fails at some point, the letters printed so far can be used to identify the problem. This is described in more detail in the technical overview. Note that some hex digits may be inserted after the first "L" if a transient disk problem occurs. Unless LILO stops at that point, generating an endless stream of error codes, such hex digits do not indicate a severe problem. ... L <error> ... The first stage boot loader has been loaded and started, but it can't load the second stage boot loader. The two-digit error codes indicate the type of problem. (See also section "Disk error codes".) This condition usually indicates a media failure or a geometry mismatch (e.g. bad disk parameters, see section "Disk geometry"). ... 0x01 "Illegal command". This shouldn't happen, but if it does, it may indicate an attempt to access a disk which is not supported by the BIOS. See also "Warning: BIOS drive 0x<number> may not be accessible" in section "Warnings". Lo que me temía: disco no soportado por la bios, o sea, demasiado grande. -- Saludos Carlos Robinson