Hi English: Can anyone tell me how I can configure Suse Linux 9.2 so that after a shutdown or "halt" (I've also tried all commands like "powerdown" etc.) command, the mashine can be turned on by "wake on lan"? It works with Knoppix linux and by keeping the Power-button pushed for some seconds but somehow Suse seems to clear the wol bits (as I suggest after reading http://lists.suse.com/archive/suse-linux/2004-Nov/2790.html). The solutions given by this page are no alternative for me or I don' t get them to work. I'm not running a dos system on this mashine, and I did't know where to put the command /ethtool -s eth0 wol bg. /I tried with the end of the file /etc/rc.d/halt.local, but this does not work. I even tried "ethtool -s eth0 wol bg" and "ethtool -s eth1 wol bg" as I use two network-cards. Thanks for any help Jost German: Kann mir jemand sagen wie ich Suse Linux 9.2 so configuriere, dass ich nach dem Herunterfahren ("halt" Befehl, ich habe aber auch alle anderen Befehle wie "powerdown" usw probiert) den Rechner mit wake on lan anschalten kann? Bei Knoppix Linux funkionierts, ebenso wenn ich den Power-Button lange gedrückt halte. Nach den Informationen auf http://lists.suse.com/archive/suse-linux/2004-Nov/2790.html gehe ich davon aus das Suse die wol Bits löscht, alle Lösungen, die auf dieser Seite beschreiben werden helfen mir nicht, da ich kein Dos System auf dem Rechner habe, und der Befehl "ethtool -s eth0 wol bg" am Ende des Skrips /etc/rc.d/halt.local keine Verbesserung bringt. Ich habe auch "ethtool -s eth1 wol bg" probiert, da ich 2 Netzwerkkarten benutze. Ich bin für jede Hilfe dankbar Jost