Am Freitag, 22. Februar 2002 15:56 schrieben Sie:
Hallo Liste, lieber Christian
Erst hatte ich ja noch den Kernel 2.4.10 von SuSE drauf (Default-Kernel von 7.3) Gleiche HD. Damit ging alles bestens. Dann habe ich den eigenen Kernel installiert, lilo.conf (siehe unten) entsprechend angepasst, lilo ausgeführt und neu gebootet. Nix geht. Per Bootdisk mit "ähnlichem" lilo-conf geht bestens. So kann es also das Bios des Systems nicht sein, denn es ging ja mal. Die Festplattenparameter sehe ich noch, dann kommmt die Meldung Starting OS und dann passiert nichts mehr.
Ich schnalle das also absolut nicht mehr. Woran das wohl liegt?
Gruss Michael
Hier nochmal die Angaben (HD 20GB): /dev/hda1 -> /boot (ext2) (Block 0-4; 30MB) /dev/hda2 -> swap (Block 5-37; 256MB) /dev/hda3 -> /(root) (ext3) (Block 38-951; ca. 7GB)
lilo.conf (HD) (orig. SuSE-lilo.conf, abgewandelt für neuen 2.4.17):
boot = /dev/hda vga = normal read-only menu-scheme = Wg:kw:Wg:Wg prompt timeout = 80 message = /boot/message
image = /boot/vmlinuz label = linux root = /dev/hda3 append = "enableapic"
image = /boot/vmlinuz.old label = linux.old root = /dev/hda3 initrd = /boot/initrd append = "enableapic"
lilo.conf für Bootdisk: # /etc/lilo.conf-floppy boot=/dev/fd0 prompt timeout=0 install=/floppy/boot/boot.b map=/floppy/boot/map lba32
image = /floppy/boot/vmlinuz label = linuxfromdisk root = /dev/hda3 read-only
Hi Michael, Du bist Dir auch sicher, daß keine Veränderungen an der Hardware seit der SuSI7.3-Installation vorgenommen wurden. Was bringt lilo -v-v für einen Output, wenn Du ihn nochmal aufrufst? Gruß CHristian