http://bugzilla.suse.com/show_bug.cgi?id=1138874 http://bugzilla.suse.com/show_bug.cgi?id=1138874#c6 --- Comment #6 from Michal Suchanek <msuchanek@suse.com> --- We don't have tags for openSUSE so here are the git commits: Release : lp151.28.4.1 GIT Revision: af35fd11466ddb32ce5df4bc094d71af8b3b86aa GIT Branch: openSUSE-15.1 Release : lp151.28.7.1 GIT Revision: f8a1872c2e97826e8e0333012932aa99b5041ddd GIT Branch: openSUSE-15.1 And these are qla patches added/removed: + patches.drivers/scsi-qla2xxx-Fix-panic-from-use-after-free-in-qla2x0.patch + patches.drivers/scsi-qla2xxx-Add-protection-mask-module-parameters.patch + patches.drivers/scsi-qla2xxx-Fix-DMA-error-when-the-DIF-sg-buffer-cr.patch + patches.drivers/scsi-qla2xxx-no-need-to-check-return-value-of-debugf.patch + patches.drivers/scsi-qla2xxx-Move-debug-messages-before-sending-srb-.patch + patches.drivers/scsi-qla2xxx-remove-redundant-null-check-on-pointer-.patch + patches.drivers/scsi-qla2xxx-Fix-LUN-discovery-if-loop-id-is-not-ass.patch + patches.drivers/scsi-qla2xxx-Add-First-Burst-support-for-FC-NVMe-dev.patch + patches.drivers/scsi-qla2xxx-Fix-unload-when-NVMe-devices-are-config.patch + patches.drivers/scsi-qla2xxx-Check-for-FW-started-flag-before-aborti.patch + patches.drivers/scsi-qla2xxx-Prevent-multiple-ADISC-commands-per-ses.patch + patches.drivers/scsi-qla2xxx-Add-support-for-setting-port-speed.patch + patches.drivers/scsi-qla2xxx-Prevent-SysFS-access-when-chip-is-down.patch + patches.drivers/scsi-qla2xxx-Move-marker-request-behind-QPair.patch + patches.drivers/scsi-qla2xxx-Fix-code-indentation-for-qla27xx_fwdt_e.patch + patches.drivers/scsi-qla2xxx-Add-new-FW-dump-template-entry-types.patch + patches.drivers/scsi-qla2xxx-Update-driver-version-to-10.00.00.14-k.patch + patches.drivers/scsi-qla2xxx-Avoid-PCI-IRQ-affinity-mapping-when-mul.patch + patches.drivers/scsi-qla2xxx-avoid-printf-format-warning.patch + patches.drivers/scsi-qla2xxx-check-for-kstrtol-failure.patch + patches.drivers/scsi-qla2xxx-Add-fw_attr-and-port_no-SysFS-node.patch + patches.drivers/scsi-qla2xxx-Remove-FW-default-template.patch + patches.drivers/scsi-qla2xxx-Fix-routine-qla27xx_dump_-mpi-ram.patch + patches.drivers/scsi-qla2xxx-Add-Device-ID-for-ISP28XX.patch + patches.drivers/scsi-qla2xxx-Add-Serdes-support-for-ISP28XX.patch + patches.drivers/scsi-qla2xxx-Correctly-report-max-min-supported-spee.patch + patches.drivers/scsi-qla2xxx-Cleanups-for-NVRAM-Flash-read-write-pat.patch + patches.drivers/scsi-qla2xxx-Add-support-for-multiple-fwdump-templat.patch + patches.drivers/scsi-qla2xxx-Update-flash-read-write-routine.patch + patches.drivers/scsi-qla2xxx-Correction-and-improvement-to-fwdt-proc.patch + patches.drivers/scsi-qla2xxx-Simplification-of-register-address-used.patch + patches.drivers/scsi-qla2xxx-Add-28xx-flash-primary-secondary-status.patch + patches.drivers/scsi-qla2xxx-Secure-flash-update-support-for-ISP28XX.patch + patches.drivers/scsi-qla2xxx-Update-driver-version-to-10.01.00.15-k.patch + patches.drivers/scsi-qla2xxx-Simplify-conditional-check-again.patch + patches.drivers/scsi-qla2xxx-Set-remote-port-devloss-timeout-to-0.patch + patches.drivers/scsi-qla2xxx-Fix-read-offset-in-qla24xx_load_risc_fl.patch - patches.suse/qla2xxx-allow-irqbalance-control-in-non-MQ-mode.patch + patches.kabi/qla2xxx-kABI-fixes-for-v10.00.00.14-k.patch + patches.kabi/qla2xxx-kABI-fixes-for-v10.01.00.15-k.patch This is openSUSE so you are free to build lp151.28.7 with the patches reverted and bisect them to determine which one breaks your setup. -- You are receiving this mail because: You are on the CC list for the bug.