http://bugzilla.novell.com/show_bug.cgi?id=556255#c2
--- Comment #2 from Charles Arnold 2009-11-17 21:52:02 UTC ---
You can also use the following work around with an ISO file after launching
'Create Virtual Machine" and getting to the "Summary" screen.
Step 1: From the "Summary" screen, Select "Operating System Installation".
Step 2: From the "Operating System Installation" screen, select "Virtual Disk"
and then "Add".
Step 3: From the "Virtual Disk" Screen, select your ISO file.
Step 4: Press "Ok" and "Apply" to return to the "Summary" screen.
Step 5: From the "Summary" screen, select "Disks".
Step 6: From the "Disks" screen highlight the ISO you just added as an
installation source and Select "Remove".
Step 7: From the "Disks" screen select "Harddisk".
Step 8: From the "Virtual Disks" screen select your ISO file. Check the
"Read-Only Access" box.
Step 9: Press "Ok" and "Apply" to return to the "Summary" screen.
Step 10: From the "Summary" screen Press "Ok" to start the installation
(assuming other settings are correct).
During the installation of the guest, you may see a warning on the
"Installation Settings" screen under the "Booting" section that says "It was
not possible to determine the exact order of disks for device map. The order of
disks can be changed in "Boot Loader Installation Details". So far, we have
not seen any adverse effects from this warning by simply ignoring it.
--
Configure bugmail: http://bugzilla.novell.com/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are on the CC list for the bug.
