http://bugzilla.novell.com/show_bug.cgi?id=494199 Summary: in initrd, either udev cannot load aic94xx-seq.fw or driver can't tell that it is loaded Classification: openSUSE Product: openSUSE 11.2 Version: Factory Platform: x86-64 OS/Version: openSUSE 11.1 Status: NEW Severity: Critical Priority: P5 - None Component: Basesystem AssignedTo: bnc-team-screening@forge.provo.novell.com ReportedBy: harbaugh@ncifcrf.gov QAContact: qa@suse.de Found By: --- User-Agent: Mozilla/5.0 (X11; U; Linux i686 (x86_64); en-US; rv:1.9.0.8) Gecko/2009032608 Firefox/3.0.8 installed opensuse factory without incident to adaptec aic-9410 controller requiring /lib/firmware/aic94xx-seq.fw file. upon rebooting newly installed system could not find root drive. while in initrd shell reloaded aic94xx module which produced the following output on the console: ... udevd[164]: seq 808 forked, pid [806], 'add' 'firmware', 0 seconds old udevd-event[806]: seq 808 exit with 0 udevd[164]: seq 808 cleanup, pid [806], status 0, 0 seconds old aic94xx: Failed to load sequencer firmware file aic94xx-seq.fw, error -2 aic94xx: couldn't init seqs for 0000:04:02.0 aic94xx: couldn't init the chip aic94xx 0000:04:02.0: PCI INT A disabled aic94xx: probe of 0000:04:02.0 failed with error -2 udevd[164]: seq 809 queued, 'remove' 'firmware' udevd[164]: seq 809 forked, pid [807], 'remove' 'firmware', 0 seconds old udevd-event[807]: seq 809 exit with 0 ... /lib/firmware/aic94xx-seq.fw is present in the initrd Reproducible: Always Steps to Reproduce: 1.Install opensuse factory to disk on internal adaptec aic-9410 controller 2.reboot on to newly installed disk 3. Actual Results: new system could not find root disk Expected Results: system should detect root disk. -- Configure bugmail: http://bugzilla.novell.com/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are on the CC list for the bug.