https://bugzilla.novell.com/show_bug.cgi?id=371756
User eich@novell.com added comment
https://bugzilla.novell.com/show_bug.cgi?id=371756#c38
--- Comment #38 from Egbert Eich 2008-11-26 03:53:47 MST ---
Then it's most likely done at the wrong place.
Here is what I've tested:
- Started installation from CD (Beta4)
- After YaST has started:
- switch to vc2
- edited /etc/ssh/sshd_config to allow password logins
- set a root password
- did: ifconfig eth0 up
- did: dhcpcd eth0
- ran: rcsshd start
- logged in from remote
(1) - on vc2 ran /bin/sh /usr/lib/YaST2/startup/YaST.call installation inital
(2) - navigated thru welcome screen purely by mouse
- when 'mode' screen showed did: 'xset r on -display :0; xterm -display :0;
input in xterm had autorepeat.
- redid step (1) and (2)
- when 'mode' screen showed did: xterm -display :0;
input in xterm had *NO* autorepeat.
So it is possible to turn it on doing 'xset r on'.
Since I don't know what actions you are performing in YaST I cannot tell you
where to turn it on. Please check your YaST command sequences and find out
where you have to enable autorepeat.
--
Configure bugmail: https://bugzilla.novell.com/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are on the CC list for the bug.