https://bugzilla.novell.com/show_bug.cgi?id=398129 Summary: 32-bit dom0 / 64-bit hypervisor combination won't boot Product: openSUSE 11.0 Version: RC 2 Platform: x86-64 OS/Version: openSUSE 11.0 Status: NEW Severity: Normal Priority: P5 - None Component: Xen AssignedTo: jbeulich@novell.com ReportedBy: jdouglas@novell.com QAContact: jdouglas@novell.com CC: carnold@novell.com, dcollingridge@novell.com, lbendixs@novell.com Found By: --- Created an attachment (id=220796) --> (https://bugzilla.novell.com/attachment.cgi?id=220796) serial output from failed boot I installed 32-bit openSUSE 11.0 (including xen) and the machine booted correctly. However, when I installed the 64-bit hypervisor package and tried to boot to it, the machine didn't finish booting. The attached log contains the serial output from the failed boot. The first boot in the log was with the 64-bit xen-dbg hypervisor. As you can see, that boot failed immediately. I then tried again with the same boot parameters but without the dbg hypervisor (just xen.gz). At the point that the boot stopped, I switched input to xen, and pressed 'd'. -- Configure bugmail: https://bugzilla.novell.com/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are on the CC list for the bug.