https://bugzilla.novell.com/show_bug.cgi?id=293039#c15 Duncan Mac-Vicar <dmacvicar@novell.com> changed: What |Removed |Added ---------------------------------------------------------------------------- Status|ASSIGNED |NEEDINFO Info Provider| |lslezak@novell.com --- Comment #15 from Duncan Mac-Vicar <dmacvicar@novell.com> 2007-08-28 04:54:13 MST --- Ok, to make sure it will work in installation. If disk partition is set manually to ZYpp, then that will be used for parsing. If it is not set, they will be detected (or try to) After that, if the partitions are empty (either by manual set, or because no detection results) everything in packages.DU is taken into account. If it is not empty (running system) only needed paths are taken into account. I just need to verify that DiskUsageCounter::detectPartitions() gives a empty result before YaST set the partitions. Ladislav? -- Configure bugmail: https://bugzilla.novell.com/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are on the CC list for the bug.