https://bugzilla.novell.com/show_bug.cgi?id=227377 andreas.pfaller@gmail.com changed: What |Removed |Added ---------------------------------------------------------------------------- CC| |andreas.pfaller@gmail.com Status|CLOSED |REOPENED Resolution|FIXED | ------- Comment #2 from andreas.pfaller@gmail.com 2006-12-10 18:39 MST ------- Why close this. The problem exists. I have just installed 10.2 with software raid (2 identical partioned SATA disks with among others / /boot /var configured as raid 1 and the system does not boot after first installation step (after the first reboot after installation). I left the bootloader configuration unchanged from the one suggested by the installer. I have booted with the rescue system and the content off all relevant partitions looks OK and the raid partitions are currently syncing. This is a NEW installation where all disks were completely repartioned. So it looks like if the only problem is the bootloader installation. Currently I am trying to figure out how to install grub manually but have not yet been successful. /etc/grub.conf contains: setup --stage2=/boot/grub/stage2 (hd0,0) (hd0,0) setup --stage2=/boot/grub/stage2 (hd1,0) (hd0,0) quit and /boot/device.map: (hd0) /dev/sda (hd1) /dev/sdb Both look OK to me. -- Configure bugmail: https://bugzilla.novell.com/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are on the CC list for the bug, or are watching someone who is.