-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 Hi Chad: I can confirm that USB in general works for me with suse 9.0 and Tyan K8W (s2885). I have not tried the printer you have but have used a printer from another manufacturer, a trackball and memory key. Good luck, - Darrell On Thursday 22 April 2004 06:38, Chad Whiting wrote:
Hello, (Newbie Here)
I am having some great difficulty in getting my hp psc 2175 to work on the thunder k8w dual opteron board. Tyan's site lists some patches etc... for the nvidia card support, but I have a kernel with all but the mtrr patch included after having done an update. It is 2.4. series kernel though.
Does the mtrr have anything to do with usb?
ptal-init setup does not see the device, even though it is listed in /proc/ bus/usb/devices. It is also listed as a scsi device. The only scsi device I have is the adaptec pci-x single channel controller card with a seageate cheetah attached. Why the printer would list out on both usb and scsi is a mystery to me.
Has anyone run into this or know if there are issues with the usb and 9.0 on this motherboard?
I also have an adaptec 4 port usb 2.0 pci card in my legacy pci slot. When plugged into this ptal will start the setup, and then hang on /dev/usb/lp0 every time when I choose scan for usb devices.
Will the 2.6.X kernel solve some of these problems? I plan on buying SuSE 9.1 when it becomes available but have went with the regular 32bit 9.0 for now until I can get the new and improved SuSE.
Thanks in advance for any help you can provide.
- -- sused@mucus.com "Perfect! ....what am I doing?" -- Washu -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.0.7 (GNU/Linux) iD8DBQFAiAAAeo6c0kw6mZ0RAiySAJ46smwDmlpc8TNw8W8BgMR77+fAfQCgkb+8 UNbR9RtRZNWmgB+G22fDAMY= =0aDV -----END PGP SIGNATURE-----