SLES 8 SP3 with two bonding interface at RX-300
Hi, A would like to use a Fujitsu RX-300 server with four NIC port (2 internal BMC5700, and 2 Intel 82546EB) bonding two virtual NIC. I tried to configure with: # ifconfig bond0 hw ether xx1:xx1:xx1:xx1:xx1:xx1 # ifconfig bond0 yyy.yyy.yyy.yyy netmask zzz.zzz.zzz.zzz broadcast vvv.vvv.vvv.vvv # ifenslave bond0 eth0 # ifenslave bond0 eth1 # ifconfig bond1 hw ether xx2:xx2:xx2:xx2:xx2:xx2 at this point i receive the following error SIOCSIFHWADDR: no such device (i tried to configure with ifcfg-bond0, ifcfg-bond1 too, but i receive error message 'ifup: Could not get a valid interface name -> skipped') If i try configure a port a single mode (as eth0,1,2,3) then it is working fine. Can you give me an advice how can i use a two bonding interface? Thanks your help, regards Ferenc
participants (1)
-
Pereszlényi Ferenc