9 Nov
2009
9 Nov
'09
17:08
Per Jessen wrote:
Per Jessen wrote:
Do you know what to do when you forget to do this, i.e. how to adjust the splash resolution _after_ the installation is completed?
I get to answer that - just change the VGA= parameter in lilo.conf. In my case from 0x31a to 0x317.
And in cases where one accidently run monitor out of range due to too high resolution, refresh rate or color depth; go to run level 3 and start sax2 in generic, low resolution mode: # init 3 # sax2 -l which makes is possible to correct the setup http://linux.derkeiler.com/Mailing-Lists/SuSE/2004-05/3270.html Rgds, Terje J. Hanssen -- To unsubscribe, e-mail: opensuse-testing+unsubscribe@opensuse.org For additional commands, e-mail: opensuse-testing+help@opensuse.org