[opensuse-factory] Realtek RTL810xE stops working after closing lid
Hello, Probably a new bug-report to file but before, I would like to write the issue I'm facing after latest TW updates I'm using a Lenovo Z470 laptop which uses the Realtek PCI Ethernet card and the r8169 kernel module. When I close the lid my laptop goes in suspend mode and when I lift the lid it resume correctly but Ethernet card remains in off-mode. If I close and open the lid again, system resumes completely, including the Ethernet card. Note: this issue affects only the Ethernet card and not the WI-Fi card. --- sudo lspci -k | grep Ethernet -A2 05:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL810xE PCI Express Fast Ethernet controller (rev 05) Subsystem: Lenovo Device 3975 Kernel driver in use: r8169 --- zypper info NetworkManager Caricamento dati del repository in corso... Lettura dei pacchetti installati in corso... Informazioni per pacchetto NetworkManager: ------------------------------------------ Repository : openSUSE:Factory Nome : NetworkManager Versione : 1.16.0-2.1 Arch. : x86_64 Fornitore : openSUSE Dimensione installata : 6,0 MiB installato : Sì Stato : aggiornato Pacchetto sorgente : NetworkManager-1.16.0-2.1.src --- Any suggestions, excluding adding custom scripts to my system? Thanks and regards, -- Marco Calistri Build: openSUSE Tumbleweed 20190327 Kernel: 5.0.3-1-default - Cinnamon 3.8.9 -- To unsubscribe, e-mail: opensuse-factory+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse-factory+owner@opensuse.org
Hi there, I have the same issue, but with Lenovo Thinkpad X230 and Intel Ethernet card on KDE. Also Tumbleweed 20190317, same NetworkManager package. ---- sudo lspci -k | grep Ethernet -A2 00:19.0 Ethernet controller: Intel Corporation 82579LM Gigabit Network Connection (Lewisville) (rev 04) Subsystem: Lenovo Device 21f3 Kernel driver in use: e1000e ---- NetworkManager log as ethernet is not working: state change: unmanaged -> unavailable (reason 'managed', sys-iface-state: 'managed') ---- Best regards, Benedek 2019. 04. 01. 17:57 keltezéssel, Marco Calistri írta:
Hello,
Probably a new bug-report to file but before, I would like to write the issue I'm facing after latest TW updates
I'm using a Lenovo Z470 laptop which uses the Realtek PCI Ethernet card and the r8169 kernel module.
When I close the lid my laptop goes in suspend mode and when I lift the lid it resume correctly but Ethernet card remains in off-mode.
If I close and open the lid again, system resumes completely, including the Ethernet card.
Note: this issue affects only the Ethernet card and not the WI-Fi card.
--- sudo lspci -k | grep Ethernet -A2 05:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL810xE PCI Express Fast Ethernet controller (rev 05) Subsystem: Lenovo Device 3975 Kernel driver in use: r8169 --- zypper info NetworkManager Caricamento dati del repository in corso... Lettura dei pacchetti installati in corso...
Informazioni per pacchetto NetworkManager: ------------------------------------------ Repository : openSUSE:Factory Nome : NetworkManager Versione : 1.16.0-2.1 Arch. : x86_64 Fornitore : openSUSE Dimensione installata : 6,0 MiB installato : Sì Stato : aggiornato Pacchetto sorgente : NetworkManager-1.16.0-2.1.src ---
Any suggestions, excluding adding custom scripts to my system?
Thanks and regards, -- To unsubscribe, e-mail: opensuse-factory+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse-factory+owner@opensuse.org
Il 01/04/19 16:00, Nagy Benedek ha scritto:
Hi there,
I have the same issue, but with Lenovo Thinkpad X230 and Intel Ethernet card on KDE. Also Tumbleweed 20190317, same NetworkManager package.
----
sudo lspci -k | grep Ethernet -A2 00:19.0 Ethernet controller: Intel Corporation 82579LM Gigabit Network Connection (Lewisville) (rev 04) Subsystem: Lenovo Device 21f3 Kernel driver in use: e1000e
----
NetworkManager log as ethernet is not working:
state change: unmanaged -> unavailable (reason 'managed', sys-iface-state: 'managed')
----
Best regards,
Benedek
2019. 04. 01. 17:57 keltezéssel, Marco Calistri írta:
Hello,
Probably a new bug-report to file but before, I would like to write the issue I'm facing after latest TW updates
I'm using a Lenovo Z470 laptop which uses the Realtek PCI Ethernet card and the r8169 kernel module.
When I close the lid my laptop goes in suspend mode and when I lift the lid it resume correctly but Ethernet card remains in off-mode.
If I close and open the lid again, system resumes completely, including the Ethernet card.
Note: this issue affects only the Ethernet card and not the WI-Fi card.
--- sudo lspci -k | grep Ethernet -A2 05:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL810xE PCI Express Fast Ethernet controller (rev 05) Subsystem: Lenovo Device 3975 Kernel driver in use: r8169 --- zypper info NetworkManager Caricamento dati del repository in corso... Lettura dei pacchetti installati in corso...
Informazioni per pacchetto NetworkManager: ------------------------------------------ Repository : openSUSE:Factory Nome : NetworkManager Versione : 1.16.0-2.1 Arch. : x86_64 Fornitore : openSUSE Dimensione installata : 6,0 MiB installato : Sì Stato : aggiornato Pacchetto sorgente : NetworkManager-1.16.0-2.1.src ---
Any suggestions, excluding adding custom scripts to my system?
Thanks and regards,
I suppose newest NetworkManager or even Kernel, could be responsible for this new issue. Developers are advised. Regards, -- To unsubscribe, e-mail: opensuse-factory+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse-factory+owner@opensuse.org
On 02/04/2019 05:48, Marco Calistri wrote:
I suppose newest NetworkManager or even Kernel, could be responsible for this new issue.
Developers are advised.
Unless you've created a bug report and are following it up the "right" developers are not necessarily advised. Not all developers read / pay attention to posts on this list as often and or as regularly as they check the bugs that are assigned to them. Unless you hear back from someone explicitly saying i'm looking into this here's the bug report you can presume that the right developer has not been notified. This list is for discussing project wide development ideas / changes not managing bug reports. -- Simon Lees (Simotek) http://simotek.net Emergency Update Team keybase.io/simotek SUSE Linux Adelaide Australia, UTC+10:30 GPG Fingerprint: 5B87 DB9D 88DC F606 E489 CEC5 0922 C246 02F0 014B -- To unsubscribe, e-mail: opensuse-factory+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse-factory+owner@opensuse.org
Il 02/04/19 04:08, Simon Lees ha scritto:
On 02/04/2019 05:48, Marco Calistri wrote:
I suppose newest NetworkManager or even Kernel, could be responsible for this new issue.
Developers are advised.
Unless you've created a bug report and are following it up the "right" developers are not necessarily advised. Not all developers read / pay attention to posts on this list as often and or as regularly as they check the bugs that are assigned to them. Unless you hear back from someone explicitly saying i'm looking into this here's the bug report you can presume that the right developer has not been notified.
This list is for discussing project wide development ideas / changes not managing bug reports.
Yes, I know that this list it is not a bug-report list. The bug-report I filed is the following: https://bugzilla.opensuse.org/show_bug.cgi?id=1131280 Regards, -- Marco Calistri Build: openSUSE Tumbleweed 20190327 Kernel: 5.0.3-1-default - Cinnamon 3.8.9 -- To unsubscribe, e-mail: opensuse-factory+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse-factory+owner@opensuse.org
On 01. 04. 19, 17:57, Marco Calistri wrote:
Hello,
Probably a new bug-report to file but before, I would like to write the issue I'm facing after latest TW updates
I'm using a Lenovo Z470 laptop which uses the Realtek PCI Ethernet card and the r8169 kernel module.
When I close the lid my laptop goes in suspend mode and when I lift the lid it resume correctly but Ethernet card remains in off-mode.
If I close and open the lid again, system resumes completely, including the Ethernet card.
Note: this issue affects only the Ethernet card and not the WI-Fi card.
Worth creating a bug report. Do not forget to attach a dmesg output after 2 suspend/resume cycles when the ethernet works again. thanks, -- js suse labs -- To unsubscribe, e-mail: opensuse-factory+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse-factory+owner@opensuse.org
-------- Original Message -------- From: Jiri Slaby [mailto:jslaby@suse.cz] Sent: Tuesday, April 2, 2019, 2:36 AM To: Marco Calistri; opensuse-factory Subject: [opensuse-factory] Realtek RTL810xE stops working after closing lid
On 01. 04. 19, 17:57, Marco Calistri wrote:
Hello,
Probably a new bug-report to file but before, I would like to write the issue I'm facing after latest TW updates
I'm using a Lenovo Z470 laptop which uses the Realtek PCI Ethernet card and the r8169 kernel module.
When I close the lid my laptop goes in suspend mode and when I lift the lid it resume correctly but Ethernet card remains in off-mode.
If I close and open the lid again, system resumes completely, including the Ethernet card.
Note: this issue affects only the Ethernet card and not the WI-Fi card.
Worth creating a bug report. Do not forget to attach a dmesg output after 2 suspend/resume cycles when the ethernet works again.
thanks,
https://bugzilla.opensuse.org/show_bug.cgi?id=1131280 Regards, -- Marco Calistri Build: openSUSE Tumbleweed 20190327 Kernel: 5.0.3-1-default - Cinnamon 3.8.9 -- To unsubscribe, e-mail: opensuse-factory+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse-factory+owner@opensuse.org
participants (4)
-
Jiri Slaby -
Marco Calistri -
Nagy Benedek -
Simon Lees